Telcobridges - Session Border Controllers
Would you like to react to this message? Create an account in a few clicks or log in to continue.

NAP status red with Availability at 0 percent and Shared usage at 100 percent

Go down

NAP status red with Availability at 0 percent and Shared usage at 100 percent Empty NAP status red with Availability at 0 percent and Shared usage at 100 percent

Post by zemogo on Wed Oct 07, 2020 7:02 pm

Hello,

I am trying lab test FreeSBC but I am having trouble getting the NAP to run.
The status is constantly Red and shows 0 availability.
NAP status red with Availability at 0 percent and Shared usage at 100 percent Napsta10


here is some information about my setup:

-Installed on ESXI 7.0

-Output from: lspci |grep Ethernet
02:00.0 Ethernet controller: Intel Corporation 82545EM Gigabit Ethernet Controller (Copper) (rev 01)
02:01.0 Ethernet controller: Intel Corporation 82545EM Gigabit Ethernet Controller (Copper) (rev 01)

- cat /proc/cpuinfo
processor       : 0
vendor_id       : GenuineIntel
cpu family      : 6
model           : 58
model name      : Intel(R) Core(TM) i5-3470 CPU @ 3.20GHz

I did run across a similar Post Previous Post on Cant Get NAP Up but it mentions the CPU type and requesting another license.

Any help on this is greatly appreciated.

Thanks,


zemogo

Number of Messages : 2
Point : 4
Registration Date : 2020-10-07
Age : 46
Address : Denver

Back to top Go down

NAP status red with Availability at 0 percent and Shared usage at 100 percent Empty Re: NAP status red with Availability at 0 percent and Shared usage at 100 percent

Post by zemogo on Wed Oct 07, 2020 7:13 pm

Ok, I had set my processors to 4 which is too many. Shocked

I set it to 2 and now the NAP is Green.

Thanks,

Lorenzo Smile

zemogo

Number of Messages : 2
Point : 4
Registration Date : 2020-10-07
Age : 46
Address : Denver

Back to top Go down

Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum