Telcobridges - Session Border Controllers
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Baremetal Install Server rebooted as soon as I started the calls

2 posters

Go down

Baremetal Install Server rebooted as soon as I started the calls Empty Baremetal Install Server rebooted as soon as I started the calls

Post by skb007 Mon Apr 13, 2020 3:49 pm

I have installed 3.1.10 freesbc bare metal version on Dell-R610. I loaded the demo configuration and created the NAP and outbound route.
my test calls were completing fine. Inbound call would match on NAP_SIP and outbound call would match on NAP_OUTBOUND.

UAC-->freesbc -->UAS

When I dialed 100 calls with 30cps from UAC towards freesbc and freesbc rebooted.

How can I find out that what caused the server to reboot?

skb007

Number of Messages : 5
Point : 11
Registration Date : 2020-04-10

Back to top Go down

Baremetal Install Server rebooted as soon as I started the calls Empty Re: Baremetal Install Server rebooted as soon as I started the calls

Post by Admin Thu May 21, 2020 12:51 am

If you create a tbreport and send it to support@telcobridges.com, we can figure it out why FreeSBC rebooted in 30 cps.

Admin
Admin

Number of Messages : 508
Point : 1199
Registration Date : 2017-11-27

http://freesbc.yetkinforum.com

Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum