Telcobridges - Session Border Controllers
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Optimizing setup for CAPS

3 posters

Go down

Optimizing setup for CAPS Empty Optimizing setup for CAPS

Post by ppierscionek Wed Sep 11, 2019 5:54 am


Let's say we have two machine cluster, each with 2x10C.
With bare-metal we get up to 500 CCPS (no radius but with a simple ruby script).
We saturate only 5 out of 20 cores under 500 CCPS (3 for apps + 2 for DPDK)

Gateway app hits 100% quota under this load.

Is there a way to optimize the config to go beyond that other than doing multiple clusters under KVM on this 2 server setup ?

I know that getting a next gen CPU can get twice the number but I would like to know if there are GENERAL ways I can tweak it. Very Happy


Number of Messages : 8
Point : 22
Registration Date : 2019-09-08
Age : 46

Back to top Go down

Optimizing setup for CAPS Empty Re: Optimizing setup for CAPS

Post by Admin Wed Sep 11, 2019 6:31 am

Dear Pawel

In those conditions, gateway application must not hit 100%. Would you contact with the support team from, please? Please include tbreport into your email.


Number of Messages : 511
Point : 1206
Registration Date : 2017-11-27

Back to top Go down

Optimizing setup for CAPS Empty Re: Optimizing setup for CAPS

Post by AndrzejP Fri Sep 13, 2019 10:41 am

some information after more testing and correcting Pawel a bit:
we used dell R620 with 2x E5-2643V2 so 2x6c not 2x10c.
After correcting routing (in first attempt we always tried first route with unavailable NAP...) and tweaking testing scenario we got about 750 CCPS with engine and gateway applications both reaching 100%. Total cpu usage was about 65%.
We only tested sip without rtp streams.

So comparing this with results on wiki we think it quite good.


Number of Messages : 12
Point : 22
Registration Date : 2019-09-11

Back to top Go down

Back to top

- Similar topics

Permissions in this forum:
You cannot reply to topics in this forum